Protective Swim Goggle Case

GUIDE TO FITTING YOUR NEW WETSUIT

When putting on your wetsuit, undo the zip and crease the suit in half so you can step into the legs of the suit. Pull the suit on using the inside, fabric-side, of the suit to avoid damaging the outside smooth neoprene with your fingernails.  Try instead to use the pads of your fingers. Also avoid rushing to put on as this will get you hot and the suit will be harder to get in to.

The seam on leg of the suit should run of the inside of the leg. The longer end of the leg holes should be aligned to the front and the shorter sides to the back. Be sure you move the neoprene in the legs up towards your crotch. Pull the neoprene in the arms of the suit towards your shoulders. Make sure not to use your fingernails at any point.

Hold the base of the zipper with one hand while using the pull cord to do the zipper up. Be sure the inner zipper panel sits flat underneath the zipper. If possible have someone help you do the zipper up. It is important to push your shoulder blades together so it is easier to pull the zip up.

The suit should fit snugly but not uncomfortably. If the collar feels too tight, be sure the suit is high enough in the hips and have someone help pull the back of the suit up through the zipper towards your shoulders.

When removing the suit undo the zipper before undoing the collar. Make sure you are holding the shoulder or body of the suit when you remove it.

TRI APPAREL SIZING

Please see our triathlon clothing sizing charts below to determine the best fit.

Men’s

Women’s